Product Description
02-0626-01 type internal gear turntable bearing can not be used in explosion hazardous environment.
Illegal use of parts may lead to dangerous accidents.
This part is designed and manufactured only for the purposes described in this installation and operation guide. Rotary connection is installed in wind power generation equipment as variable pitch, yaw and main bearing.
Gear ring in
The sliding bearing of wind power equipment is installed as an azimuth gear ring.
Elsewhere in this instruction manual, rotary connection and gear ring will no longer be distinguished. The relevant instructions applicable to rotary connection are applicable to gear rings as long as they are useful. If in doubt, please contact the customer service.
Service department (page 2).
It is not allowed to modify, reconfigure or change the structure of the part or a part of the part to change the application scope or purpose of the part. Such behavior is illegal use of the product.
For the losses caused by illegal use of products, customers will lose relevant rights. All losses caused by not using products according to regulations shall be borne by the operators themselves.
Special hazards will be described below.
Please observe the safety tips listed here and those given in the later chapters of this instruction manual.
To reduce and avoid dangerous situations as much as possible.
To reduce and avoid dangerous situations as much as possible.
Please keep away from children and store it.
It carries out correct cleaning. If this is not used as required.
Materials are in danger of suffocation. Avoid contact between VCI film and skin and eyes. repeatedly
Or prolonged skin contact may lead to skin degreasing and dermatitis.
Moving parts
During the operation of 02-0626-01 type internal gear turntable bearing equipment,
, it is strictly prohibited to engage in moving parts or work on moving parts. Do not open the cover during operation. Pay attention to running time: before opening the cover plate, please make sure that no parts are in running state. Please wear close-fitting protective clothing when you are in a dangerous area. Rotating and/or straight running parts may cause serious injuries! During the operation of falling materials and equipment, it is forbidden to step into dangerous areas. During the operation, those heavy materials may fall or fly out outside the control range, which may lead to serious injury or even death.
Garbage and surrounding material.
Please keep the work area clean and remove unnecessary materials. Please mark the uneven places with yellow and black marking tape. Garbage and surrounding materials may cause the danger of slipping and tripping and may cause serious injuries.
Audited Supplier 
){kind=link}